Ram-trucks 2013 Chassis Cab - User Guide User Manual download pdf (Page 100)

Programming A Rolling Code

NOTE:

For programming Garage Door Openers that were manufactured after 1995. These

Garage Door Openers can be identified by the “LEARN” or “TRAIN” button located

where the hanging antenna is attached to the Garage Door Opener. It is NOT the

button that is normally used to open and close the door. The name and color of the

button may vary by manufacturer.

1. Place the ignition switch into the ON/RUN position.

2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink

button you wish to program while keeping the HomeLink

indicator light in view.

3. Simultaneously press and hold both the Homelink

button you want to program

and the hand-held transmitter button.

4. Continue to hold buttons until the EVIC display changes from “CHANNEL #

TRAINING” to “CHANNEL # TRAINED”, then release both buttons.

NOTE:

If the EVIC displays “DID NOT TRAIN” repeat from Step 2.

5. At the garage door opener motor (in the garage), locate the “LEARN” or

“TRAINING” button. This can usually be found where the hanging antenna wire

is attached to the garage door opener motor. Firmly press and release the

“LEARN” or “TRAINING” button.

NOTE:

You have 30 seconds in which to initiate the next step after the LEARN button has

been pressed.

6. Return to the vehicle and press the programmed HomeLink

button twice

(holding the button for two seconds each time). The EVIC will display “CHANNEL

# TRANSMIT”. If the garage door opener/device activates, programming is

complete.

NOTE:

If the device does not activate, press the button a third time (for two seconds) to

complete the training.

7. To program the remaining two HomeLink

buttons, repeat each step for each

remaining button. DO NOT erase the channels.

ELECTRONICS

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 171 172

No comments

Ram-trucks 2013 Chassis Cab - User Guide User Manual Page 100